john deere mini excavator bucket pin sizes

Sadly there are no obvious increments for the dipper gap, so it is best to work to the nearest millimetre, allowing up to 2mm for wear and tear. The most simple way of measuring the dipper gap is to remove your pin and slot the tape measure through one hole, and press the tip of the tape measure against the boss at the opposite side.

If it is tight and hard to fit to your machine, think about adding a millimetre. See how the bucket fits on your machine, if it has a lot of play, deduct a millimetre or two. Please watch of for the wear and tear on your buckets, as a worn boss or a bent hanger can often give you a false reading. Generally the tolerance levels for the dipper gap are quite forgiving, however they are often measure with +/- 2mm. Get it wrong and it could mean that your bucket does not fit, or alternatively fits but has a lot of slack, meaning your bucket rocks from sided to side when the digger is in operation. The dipper gap is probably one of the more important measurements. Quick Tip: Align the 10cm/100mm mark on your tape measure, then subtract 100mm A handy tip is the bucket pins tend to be in 5mm or 1/5-inch intervals, for example 25mm, 30mm, 35mm, 40mm and so on! Either use a pair of Vernier callipers or tape measure to measure the width of the pin body, or use the hole in the side of the bucket, providing neither are worn out too much.

This is simply the diameter of the pin that is used to mount the bucket or attachment to your machine. While tape measures are probably the most common measuring device in anybody’s toolbox, we also suggest that for the most accurate method using either a steel ruler, and/or a pair of Vernier callipers for the pin diameter. You can use a tape measure to accurately measure all the dimensions you need. Tipping Links / Side Links / Banana LinksĪ tape measure.Rake Riddle Buckets / General Purpose Rake.Kubota Quick Attach Buckets & Attachments.

John deere mini excavator bucket pin sizes